Introduction of Best Triple beam balance structure

Best Triple beam balance is so named because of its three graduated beam scales. Best Triple beam balance has three sets of yardages but no weights. First use the yardstick with the largest scale. If the pointer does not return to zero, then adjust the yardage with the smaller scale. Best Triple beam balance has three bars, each bar has weights of different masses placed on it, and you can adjust the resistance to the opposite side of the object with the balance fulcrum as the center by moving the weights. The object to be tested is placed in the weighing paper or the weighing pan and then placed on the weighing pan of the balance.

Best Triple beam balance mainly uses the position of three weights on the three beams to measure the mass of the object.

The top bar has ten engraved teeth, ranging from 0g, 1g, 2g, *.. all the way from left to right to 10g.

On the crossbar in the middle, there are ten engraved teeth from zero to 100 grams, and each engraved tooth is in units of 10 grams.

The bottom bar is from zero to 1 gram, and is first divided into ten scales by the large scale, and each scale is in 1.0 gram units. Then divide each 0.1 gram unit in half by the middle scale, and each middle scale is 0.05 gram. Finally, the small scale divides each two large scales into ten equal parts, and each small scale is 0.01 grams.

There are two short rods on the right straight beam of the three horizontal rods of Best Triple beam balance, which can be hung with heavy weights (two weights with hanging holes are inserted into the right end of the balance base), each additional hanging one The weight of the balance increases by 100 grams.